BASICS
A few simple tools are required:
- Measuring tape
- Power drill, drill bits
- Hex head and/or Phillips driver bit
- Pencil
Additional fasteners other than those sent with your shade may be required
depending on the mounting surface. Wallboard and plaster require the use
of anchors such as expansion or toggle bolts. Brick, tile or stone need
special plugs and drill bits. Remember to always pre-drill holes in wood to
avoid splitting.
Standard and
Top-Down Bottom Up
Installation Bracket
Side Track
Rail with
Magnet
Magnet with
Foam Tape
MOUNT THE SHADE
The minimum required depth for installation is 1-1/2”. The minimum depth
required for Flush mount installation is 2”.
BRACKET INST
ALLATION
Shades are shipped with the required
number of brackets for proper installation.
End brackets should be located with
centerlines 2-1/2" in from each end.
Depending on the width of the shade,
additional brackets may be necessary
evenly spaced between the two end
brackets.
Continuous Loop
Installation Bracket
Continuous Loop Brackets
Position the headrail with the front lip (A) resting on the top hooks of all
brackets. Make sure no fabric is pinched between the bracket and headrail.
Push the bottom of the
headrail firmly upwards and
toward the window until the
groove at the bottom of the
headrail snaps into place,
(B) as shown.
Standard Brackets
Insert the front clip of the installation bracket into
the front groove of the rail.
Push the rail back and up until the back clips of the
bracket are inserted in the back groove of the rail.
toward the window.
TRACK MOUNTING
Mount the shade.
NOTE: DO NOT REMOVE THE RELEASE
LINER FROM THE MAGNETS YET.
Place the top end of the track into the slotted
end caps and carefully slide up into place (Fig
1).
While holding the track in place, measure the
distance from the front of the track to the edge
of the window frame at the top.
Mark the bottom of the window at the same
point as the top measurement (Fig 2). Repeat
for other side.
Remove the shade. Peel the release liner back
from the magnet.
Carefully line the front edge of the track up to
the top and bottom marks without letting the
tape touch the window frame (Fig 3).
When correctly lined up, press the tape
against the frame. Push firmly from top to
bottom to ensure a good adhesion (Fig 4).
Repeat for the other track.
Pull the tracks off the magnets and reinstall the
shade.
Carefully slide the top of the track into the
notch in the shade and push up.
Let the track snap onto the magnet. Repeat for
the other side.
SHADE INSTALLATION
Standard and Continuous Loop
Unwind the cord from the shade. Bring the top rail up near the installation
brackets. Center the shade in the window opening and attach the headrail
to the installation brackets.
For shade Use this Number
widths of: of brackets:
Up to 40” 2
40" - 72" 3
72" - 84" 4
84" and up 5
OPERATION
Standard Shades
To lower or release shade, pull the cord inward toward the center of the
shade. To raise or lock the shade, pull the cord straight down and outward
toward the edge of the shade.
Top-Down Bottom Up
One cord will raise or lower the bottom rail, the other cord will raise or lower
the top. Pull the cord inward toward the center of the shade to lower or
release shade. Pull the cord straight down and outward toward the edge of
the shade to raise or lock the shade.
Continuous Loop Shades
Operate the shade by pulling down on one side of the cord. One side of the
cord raises the shade, the other side lowers the shade. Do not lift the bottom
rail with your hands. Also, be careful not to place objects on the window sill
that will interfere with operating the shade or cause it to hang unevenly.If the
shade does become crooked, simply lower it as far as it will go and then
raise it again. This will ensure that all the lift lines inside the shade are
pulling up evenly.
Standard Brackets
The brackets are mounted flat against the top sill surface.
The minimum depth required is 1-1/2”.
To fully recess the shade requires a flat
surface with a minimum depth of 2".
(5 pages)
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals